Shenyang longcheng high polymer decorative materials Co.Ltd

Now please let LongCheng explains to you UV marble

Seo:http://www.uvmarblepanel.com/news/4.html
Release time:2015-08-27

New UV board installation method 1: aluminum alloy fixed
(1) to overlying on one side at the grass-roots level in metope, commonly used is 3 mm plywood, block board, good point is fireproof glass magnesium board! Gas nailed them on the wall!
(2) go up in metope nail crural line. With the shade aluminum alloy, aluminum alloy tool with fixed corner corner. Shade is respectively the aluminum alloy and aluminum alloy bar with a nail in the corresponding position of metope.
(3) and saw UV plate. Will UV board according to the requirements of actual size cut into piece by piece, and then saw edge trim with sand paper smooth and clean!
(4) the shade then UV board embedded in aluminum alloy and bar! (on the picture you will see some understand)
New UV board installation method 2: with glue of metope installed!
(1) to overlying on one side at the grass-roots level in metope, commonly used is 3 mm plywood, block board, good point is fireproof glass magnesium board! Gas nailed them on the wall! With a clean sand paper will board face clean!
(2) the sawing plate. The UV board saw Ann actual requirements into pieces!
(3) side. To install the UV plate with four edges of edge machine, pour into a 45 degree Angle. According to the actual installation requirements, some just fell on both sides of the up and down or three side!
(4) clean UV panel on the back! Use sand paper and cloth UV board on the back to clean.
(5) smear adhesive or woodworking glue evenly on the back of the UV board, then UV board flat on the wall, reoccupy hand gently against the UV board, make the UV plate firmly stick on the wall!
(6) the water-based joint sealant. Then joint sealant filled in two UV plate 45 degree Angle intersect, fill first, reoccupy board vertical Angle from 45 degree Angle intersect lightly across, so that intersect 45 degrees is good!
(7) clean UV board surface, clean extra joint sealant! Then it is done.